Multilayer switch configuration pdf
MULTILAYER SWITCH CONFIGURATION PDF >> READ ONLINE
Catalyst 6000 and 6500 Series Multilayer Switch Module Installation and Configuration Note 7 Functional Description Connecting a Terminal To connect a terminal to the console port using the cable and adapters provided with the Catalyst 6000 family switch, ensure that the console port mode switch is in the in position (factory default position). Free YouTube Playlists from Keith:Master Playlist for Cisco CCNA 200-301 ogit.online/slothCisco CCNA 200-301 Security ogit.online/200-301_Sec Step 1: Enable routing capability on the switch. Even though this command is usually enabled, it does not hurt to be certain that it is. Switch (config)#ip routing. Step 2: Take note of the VLANs that must be routed. Based on the network topology above, it is VLANs 10, VLAN 20, and VLAN 30. Step 3: Use the 'show vlan' command to verify that For the Layer 3 forwarding functions to work, the routing functions in the multilayer switch learn about other networks, paths to destination networks and destinations, through dynamic IP routing protocols or via static/manual configuration information provided by a network administrator. Multilayer switch. Content switch. IDS/IPS. Load balancer. Multifunction network devices work. In fact, switches are sometimes called multiport bridgesbecause of how they operate. 102 Chapter 3: Introduction to Networking Routers In a common configuration, routers are used to create larger networks by join-ing two network segments. A small Step 2: Clear any existing configurations on the switches, and initialize all ports in the shutdown state. If necessary, refer to Lab 2.5.1, Appendix 1, for the procedure to clear switch configurations. It is a good practice to disable any unused ports on the switches by putting them in shutdown. Disable all ports on the switches: Switch#config A multilayer switch (MLS) is a computer networking device that switches on OSI layer 2 like an ordinary network switch and provides extra functions on higher OSI layers.The MLS was invented by engineers at Digital Equipment Corporation.. Switching technologies are crucial to network design, as they allow traffic to be sent only where it is needed in most cases, using fast, hardware-based methods. Multi-layer switch (MLS) architectures take advantage of recent advances in transport systems, optical switching, electrical. switching, and routing algorithms to significantly reduce the cost of MySwitch (config-if)#exit. The following commands will select a range of interfaces (from 1 to 24) and add all of them to vlan20. MySwitch (config)#interface range gigabitEthernet 0/1-24. MySwitch (config-if)#switchport mode access. MySwitch (config-if)#switchport access vlan 20. Multilayer switches contain both a switching and routing engine. A packet must first be "routed," allowing the switching engine to cache the IP traffic Router(config)# ip cef Router(config)# interface serial0/0 Router(config-if)# ip route-cache cef To view CEF information:
547, 974, 374, 125, 853.
0コメント